Motorola AT Commands G24-L Developer's Manual page 54

AT Commands Summary
AT Command
TCP/IP Commands
+MIPCALL
+MIPOPEN
+MIPODM
+MIPCLOSE
+MIPSETS
+MIPSEND
+MIPPUSH
+MIPFLUSH
+MIPRUDP
+MIPRTCP
+MIPSTAT
+MIPXOFF
+MIPXON
+MIPCONF
+MPING
+MPINGSTAT
+MSDNS
+MIPCFF
NOP Compatible
Ignored (Compatible Only) Commands
%C
1-24
Table 1-1: AT Commands (Cont.)
Description
This command creates a wireless PPP connection with the GGSN,
and returns a valid dynamic IP for the G24-L.
This command causes the G24-L to initialize a new socket and open
a connection with a remote side.
This command causes the G24-L to initialize a new socket in Online
Data Mode and open a connection with a remote side.
This command causes the G24-L to free the socket accumulating
buffer and disconnect the G24-L from a remote side.
This command causes the G24-L to set a watermark in the
accumulating buffer. When the watermark is reached, data is pushed
from the accumulating buffer into the protocol stack.
This command causes the G24-L to transmit the data that the
terminal provides, using an existing protocol stack.
This command causes the G24-L to push the data accumulated in its
accumulating buffers into the protocol stack.
This command causes the G24-L to flush (delete) data accumulated
in its accumulating buffers.
This unsolicited event is sent to the terminal when data is received
from the UDP protocol stack.
This unsolicited event is sent to the terminal when data is received
from the TCP protocol stack.
This unsolicited event is sent to the terminal indicating a change in
link status.
This unsolicited event is sent to the terminal to stop sending data.
This unsolicited event is sent to the terminal when the G24-L has
free memory in the accumulating buffer.
Configure Internal TCP/IP stack.
This command will allow verifying IP connectivity to another
remote machine (computer) by sending one or more Internet Control
Message Protocol (ICMP) Echo Request messages.
This is the unsolicited response that the G24-L sends to the terminal
to inform of ping execution status update and provide summary
statistics of ping request when ping request execution is completed.
This command sets/reads DNS IP address for each socket.
This command sets the Filtering List..
This command is supported for backward compatibility only, and
has no effect.
G24-L AT Commands Reference Manual
Page
Page 3-276
Page 3-277
Page 3-279
Page 3-282
Page 3-283
Page 3-284
Page 3-285
Page 3-286
Page 3-287
Page 3-287
Page 3-288
Page 3-288
Page 3-289
Page 3-289
Page 3-289
Page 3-296
Page 3-299
Page 3-301
Page 3-304
April 15, 2008