Table of Contents
Advertisement
User Guide: PTP 800 Licensed Ethernet Microwave
If the network adaptor supports advanced properties then ensure that Ethernet
Speed and Duplex are both configured for automatic negotiation. One example,
based on a Broadcom™ adaptor, is shown in
Figure 5-27 Setting network adaptor advanced properties
Connecting the PC
Connect the PC Ethernet port to the Management port of the CMU using a suitable
standard (not crossed) Ethernet cable.
Switching on the CMU
Switch on the CMU power supply.
Wait until the CMU status indicator shows green steady or green slow blink. This
normally occurs within 60 seconds from applying power.
phn-1478_005v000
Apr 2010
Connecting the CMU to a PC or workstation
Figure
5-27.
5-89
Advertisement
Table of Contents
