Table of Contents
Advertisement
Upgrading the PTP 800
Upgrading PTP 800 software
Perform this task to upgrade the units to a new version of PTP 800 operational
software.
NOTE
To upgrade the software, proceed as follows:
Procedure 6-15 Upgrade software
1
Download and save the new software image (PTP 800-nn-mm.dld2).
2
From the left hand menu, select Software Upgrade. The Software Upgrade
page is displayed
Select Browse. Navigate to the folder containing the downloaded software
3
image and select Open.
4
Select Upload Software Image. The Software Upgrade Confirmation page
is displayed
5
Select Program Software Image into Non-Volatile Memory. The
Progress Tracker page is displayed. On completion, the Software Upgrade
Complete page is displayed
6
Select Reboot Wireless Unit. Select OK to confirm. The unit reboots with
the new software installed.
6-34
Before performing a software upgrade, save the configuration as
described in
Saving and restoring system configuration
the unlikely event that a unit has to be replaced in the field, the
replacement unit can be reconfigured by restoring the saved
configuration file.
(Figure
(Figure
6-17).
6-16).
(Figure
6-18).
Chapter 6 Operation
on page 6-31. In
phn-1478_005v000
Apr 2010
Advertisement
Table of Contents
