Reviewing And Updating System Configuration; Table 6-8 System Configuration Attributes - Motorola PTP 800 User Manual

Configuring the wireless interface

Reviewing and updating system configuration

Perform this task to review and update the system configuration an operational or
newly installed PTP 800 link.
To review and update the system configuration of a PTP 800 link, proceed as
follows:
Procedure 6-5 Review and update system configuration
1 From the left hand menu, select Configuration. The System Configuration
page is displayed
Review and update the system configuration attributes
2
If any attributes have been updated, select Submit Updated System
3
Configuration.

Table 6-8 System Configuration attributes

Attribute
Transmitter
Link
Link Name
Site Name
Antenna
Antenna Gain
RF Feeder Loss
IF Cable
IF Cable Length
Modem
6-14
(Figure 6-7).
The transmitter can be enabled as described in
wireless transmission
described in Disabling wireless transmission
11.
Read only. This attribute is set in the Installation wizard
(Table 5-6).
The Site Name can be updated as described in
site name on page 6-13.
Read only. This attribute is set in the Installation wizard
(Table 5-6).
Read only. This attribute is set in the Installation wizard
(Table 5-6).
Read only. This attribute is set in the Installation wizard
(Table 5-6).
Chapter 6 Operation
(Table
Meaning
on page 6-11, or disabled as
phn-1478_005v000
6-8).
Enabling
on page 6-
Updating
Apr 2010