User Guide: PTP 800 Licensed Ethernet Microwave
Configuring generation of diagnostic alarms
Perform this task to select which diagnostic alarms will be notified to the system
administrator via the network SNMP management agent or SMTP email server.
Before performing this task, ensure that the 'Enabled Diagnostic Alarms' box has
been ticked in either the SNMP or SMTP sections of the Remote Management
page. For more information, see
notifications
page
6-49
To configure the generation of diagnostic alarms, proceed as follows:
Procedure 6-23 Configure diagnostic alarms
From the left hand menu, select Diagnostic Alarms. The Diagnostic Alarms
1
page is displayed
Tick the boxes against the required alarms
2
Select Submit Updated Configuration.
3
Figure 6-23 Diagnostic Alarms page
phn-1478_005v000
Apr 2010
on page
6-44
and
Configuring the CMU to generate email messages
(Figure
Configuring the CMU to generate SNMP
6-23).
(Table
Managing faults
6-17).
on
6-47