Table of Contents
Advertisement
System management
Configuration pages
The web-based interface includes a number of configuration pages. These pages
allow for modification of the system configuration of an installed link. In general,
configuration changes can be completed without a reboot. Configuration pages
include controls relating to the management agent IP interface, the Ethernet
interfaces, quality of service at the wireless interface, security passwords and AES
keys.
SNMP
The management agent supports fault and performance management by means of
an SNMP interface. The management agent is compatible with SNMP v1 and
SNMP v2c, using the following MIBs:
x
PTP 800 enterprise MIB
x
The system group and the interfaces group from MIB-II, RFC-1213
x
The interfaces group and the ifXTable from RFC-2233
x
The dot1dBase group and the dot1dBasePortTable group from the Bridge
MIB, RFC-1493.
The PTP 800 enterprise MIB is available for download in the application software
package from http://www.motorola.com/ptp/software.
SNMP must be enabled for use by means of the SNMP State attribute in the web-
based interface. Activation of SNMP in PTP 800 requires a reboot of the CMU.
The web-based interface must be used to configure the destination IP address for
SNMP notifications, and to enable or disable generation of each supported SNMP
notification. Supported notifications are as follows:
x
Cold start
x
Link up
x
Link down
x
Link name mismatch
x
Alignment mode
x
Unit out of calibration
x
Encryption enabled mismatch
x
Wireless link disabled warning
x
Data port disabled warning
x
Data port fiber status
x
Data port configuration mismatch
x
SNTP sync
1-32
Chapter 1 Product description
phn-1478_005v000
Apr 2010
Advertisement
Table of Contents
