Table of Contents
Advertisement
User Guide: PTP 800 Licensed Ethernet Microwave
Table 5-6 Step 1: Equipment Configuration attributes
Attribute
Link
Link Name
Site Name
Antenna
Antenna Gain
RF Feeder Loss
ODU
ODU Status
ODU Type
ODU Serial
ODU Tx Power Min
ODU Tx Power Max
phn-1478_005v000
Apr 2010
Enter a meaningful name for the PTP link. It is used to
establish a connection with the PTP 800 at the other link
end (site). The Link Name must be the same at both ends
of the link.
Enter a descriptive name for the site together with any
additional notes. This is used for reference only.
Enter the antenna gain (dBi), as specified in
specifications
on page 4-13.
Enter the loss (dB) in the feeder (waveguide) between the
ODU and antenna, including loss of couplers. This should
be zero for a direct mount configuration. Waveguide
specifications are provided in
specifications
on page
The status of the ODU.
This is set in the factory. It consists of frequency band,
Tx-Rx frequency spacing, Hi or Lo band and transmit
frequency range.
This is set in the factory. It uniquely identifies the ODU.
This is set in the factory. It is the absolute minimum
transmitter power level.
This is set in the factory. It is the absolute maximum
transmitter power level.
Value
Flexible waveguide
4-23
Installation wizard
Antenna
5-93
Advertisement
Table of Contents
