Table of Contents
Advertisement
Configuring the IP and Ethernet interfaces
Configuring bridged Ethernet traffic
Perform this task to configure the attributes of bridged Ethernet traffic at the
CMU.
To configure bridged Ethernet traffic, proceed as follows:
Procedure 6-9 Configure bridged Ethernet traffic
1
From the left hand menu, select Configuration, LAN Configuration. The
LAN Configuration page is displayed
Review and update the bridging attributes
2
If any attributes have been updated, select Submit Updated System
3
Configuration.
Table 6-12 Bridged Ethernet traffic attributes
Attribute
Local Packet Filtering
Management
Committed Information
Rate
6-26
(Figure
If Local Packet Filtering is enabled, the management
agent learns the location of end stations from the
source addresses in received management frames. The
agent filters transmitted management frames to ensure
that the frame is transmitted at the Ethernet (data or
management) port, or over the wireless link as
appropriate. If the end station address is unknown,
then management traffic is transmitted at the Ethernet
port and over the wireless link.
In out-of-band local management mode, management
frames are not transmitted over the wireless link, and
so address learning is not active.
Only displayed when Management Mode is set to 'Out-
of-Band'.
Select the minimum data rate (range 200 to 2000
Kbit/s) that the network will guarantee to be available
for management traffic.
Chapter 6 Operation
6-9).
(Table
6-12).
Meaning
phn-1478_005v000
Apr 2010
Advertisement
Table of Contents
