Table of Contents
Advertisement
Programming Manual for Digital Key Telephone System
300 & LDK-100
system speed number.
7. System Speed numbers are protected when
the system power is off.
SYSTEM SPEED ZONE GROUP
Description
Up to 10 speed number zones can be defined.
Speed bins & stations can be allocated to these
zones. Toll checks based on COS can be applied
to zones. Only stations allocated to zones can
access these bins. Speed bins not allocated to
zones can be accessed by all stations and no toll
checks are applied
Admin Programming
n
Speed Dial Access (PGM 112-BTN 9)
n
System Speed Zone Access (PGM 232)
n
Dial Tone Detect (PGM 160-BTN 6)
VOIP CALL–DIRECT CALL
Description
This feature is e stablished receiving IP numbers
or dialing IP numbers directly.
Operation
1. Press the desired {CO} line, {POOL}, or
{LOOP} button or dial the CO line or group
code
2. When hearing Dial Tone, dial the IP address
of Called Party sequentially. In stead of ".", "*"
must be dialed.
3. (ex: IP Address: 156.147.3.201,
number:156*147*3*201)
4. Press "#" button to call.
5. If Called Party is LDK system, Ring will follow
the Ring Assignment(PGM144)
Admin Programming
n
CO Line Service Type (PGM 140) – Normal
Co
n
VOIB IP Setting (PGM 340)
n
ISDN Enblock Sending(PGM143-Btn6)
Condition
1.
When programming Speed Dial for Direct
Call, "#" must not be inserted.
(ex: To assign 156*147*3*139 to Speed Dial,
Just
"156*147*3*139#")
2.
In DISA Incoming, Co Access is denied if the
line seized by dialing Co Access Code is
VOIB line
VOIP CALL–CALL BY NETWORK TBL
Description
This feature is established dialing Station number
programmed in Network Table(PGM324)
Operation
1.
Dial the station number included in the range
from Start Range to End Range in Network
Table.
2.
System will select one VOIP Co line in the
CO Group assigned in Network Table
3.
User will be heard Ring Back Tone if this call
is possible.
4.
In case of Error or Busy, Call will follow
DID/DISA Destination(PGM167).
Admin Programming
n
CO Line Service Type (PGM 140) – ISDN
DID/MSN
n
VOIB IP Setting (PGM 340)
n
ISDN
Enblock
(ON/OFF)
n
Dialed
DID Digit Conversion(PGM230) – (used in
case of Did Conversion Type 0 or 2)
n
Flexible DID Table(PGM231) – (used in case
of DID Conversion Type 2)
n
Networking CO Program(PGM322 - Btn1)
n
Networking Routing Table(PGM324)
Condition
1. For the call via Network Table, VOIB call
follows the ISDN DID Call Procedure.(DID
1-20
CO Line Features
enter
"156*147*3*139"
Sending(PGM143-Btn6)
LDK-
not
–
Advertisement
Table of Contents
