Table of Contents
Advertisement
Programming Manual for Digital Key Telephone System
300 & LDK-100
3. SYSTEM FEATURES
ACCOUNT CODE
Description
While on an outside call, users can enter a
series of digits that will be included in the SMDR
call record. The series of digits, 'Account Code'
can be used to allocate cost or time for the call.
It provides to track specific calls by entering a
non-verified, and variable length (max. 12 digits)
identifiers.
Operation
To enter an account code before accessing a
CO line,
1. Press the {ACCOUNT CODE} flexible button.
2. Dial the account code (max. 12 digits) or
mark , then reconnected to the external
party.
3. Intercom dial tone is heard.
4. Seize a CO line to make a call.
To
enter
an
account
conversation with an external party;
1. Press the {ACCOUNT CODE} flexible button.
2. Dial the account code (max. 12 digits).
3. Press the {ACCOUNT CODE} flexible button,
the user is reconnected to the external party.
To enter an account code without {ACCOUNT
CODE} flexible button during a conversation
with an external party,
1. Press the [TRANS/PGM] button.
2. Dial 5 5 0.
3. Dial the account code (max. 12 digits) or
mark , then reconnected to the external
party.
Condition
1.
For keysets, you may assign a flexible button
as {ACCOUNT CODE} to access the account
code feature.
[TRANS/PGM] + Flex. BTN + [TRANS/PGM] +
8 0 + [HOLD/SAVE]
2.
While entering account code, it is impossible
to talk to the other party.
3.
The user may enter the account code before
a call conversation is established.
code
during
a
3-1
ALARM
Description
The system can be programmed to recognize
the status of an external contact (normally open
or closed) from a relay. When activated, the
system will signal programmed stations with a
single tone repeated per 1-min. interval or a
continuous tone. This capability is commonly
employed to provide remote alarm signals.
When used as an alarm, the assigned stations
receive the programmed signal. To stop the
signal, the alarm should be deactivated (reset)
from a station assigned to receive the alarm
signal.
Operation
At detecting the Alarm contact, the system sends
the appropriate alarm signal to assigned stations.
To terminate the alarm signal while idle status;
Dial 5 6 5 and confirmation tone is heard. The
alarm signal is terminated at all assigned
stations.
To re-arm alarm;
Clear the alarm condition and reset (terminate)
the alarm signal. The proceeding steps can be
done in any order to rearm.
Admin Programming
n
Alarm Enable (PGM 163-BTN 1)
n
Alarm Contact Type (PGM 163-BTN 2)
n
Alarm Signal Mode (PGM 163-BTN 4)
n
Alarm/Door Bell Signal (PGM 113-BTN 8)
Condition
1. An external contact should be connected to the
alarm input on MBU.
2. The alarm contacts should be "dry" (no
voltage/current source connected).
3. SLT cannot receive alarm signal.
4. Alarm reset can be programmed in a flexible
button.
LDK-
System Features
Advertisement
Table of Contents
