Table of Contents
Advertisement
Programming Manual for Digital Key Telephone System
300 & LDK-100
-
LOOP button: Pressing the flexible button, a
CO line may be accessed
Admin Programming
n
Flexible Button Assignment (PGM 115)
n
CO Line Programming (PGM 112-BTN 6)
Condition
1. A flexible button that is not assigned as {CO
Line} button is considered as "Feature"
button and is programmable at each station.
When
PGM
112-BTN
Programming) is enabled, the flexible button
that is assigned as {CO line} button can be
programmed.
2. To assign flexible button,
-
[TRANS/PGM] + Flex. BTN + [TRANS/PGM] +
Feature Code + [HOLD/SAVE]
(Refer to 1.4.3: Flex Button Programming Code at
Programming Manual.)
3.
To assign direct button, (e.g. CO btn or DSS btn)
[TRANS/PGM] + Flex. BTN + Disired Code +
[HOLD/SAVE]
STATION PROGRAMMING MENU
Description
The system supports multiple hierarchical menus
based on station programming. User can make
station programming by selecting desired menu.
Attendant also can make station programming
and attendant programming with the same way.
(Refer
to
the
Station
Table/Attendant Programming Menu Table.)
Operation
To enter programming mode,
1. Press the [TRANS/PGM] button.
2. You may find the following menu;
[1] RING
[2] COS
(Normal Station)
[0] ATTENDANT
[1] RING
(Attendant Station)
6
(CO
Line
Programming
Menu
2-14
To search other programming menu,
With [UP]/[DOWN] key, you can search the
previous/next menu.
To select a menu,
1. Dial the number of desired menu item to
select the menu.
2. If the selected menu is programming item, it
enters to programming mode.
3. If there is available sub-menu, selectable
menu is displayed on the LCD.
Condition
1. Press the [TRANS/PGM] button to move the
top menu.
2. Press the [REDIAL] button to move the
previous menu.
3. After a menu is programmed, the previous
menu list is displayed on the LCD.
4. Pressing a Flex. button in main menu mode,
it enters flexible button programming mode.
STATION RELOCATION
Description
This feature allows to unplug a station and plug it
at another location. You may just dial a code to
copy or bring all of the attributes of the station
including extension number, button mapping,
speed dial, class of service, etc.
Operation
To store the station attributes to a temporary
buffer,
1. Dial the feature code 5 6 1.
2. Unplug the station.
To retrieve stored station attributes,
1. Plugging it at another properly wired jack, dial
5 6 2.
2. The station will be relocated. Then, the all
station attributes are copied to the current
station.
Condition
1.
All information for the port of destination
station will be retained so that it may be
LDK-
Intercom Features
Advertisement
Table of Contents
