Figure 4-5 Termination Board - ABB XSeries G4 6200 User Manual

J12 Jumper:
Jumper Pin1 to Pin 2 for AI
Jumper Pin 2 to Pin 3 for DOUT2
(WHT) RTD OUT
(WHT)
RTD +
(BLK)
RTD -
RTD PROBE
(BLK)
RTD IN
(DRAIN)
SHIELD
G4
XFC 6200EX
POWER/TERM
BOARD
2103344-XXX
J11 Terminates RS-485
6) Gain access to the G4 EX board by loosening the countersunk hex socket
7) After the end cap has been removed, gently pull the graphic overlay plate
8) Using a small slot head screw driver, remove the four screws that hold the
9) Gently disconnect the LCD board from the G4 EX board, J2 connector (see
Page 4–10
AIs/DIs/DOs
J3
+ AI - + DI -
J12
J6
1 3
J8
I/O EXPANSION
5
4
6
3
1
2
S2
1
J2
ETHERNET
RTD
SECURITY
J7
USB CLIENT
J4
J21
1
MMI
J20
COMM2
1 2 3 4
1
J11
on COMM2
Figure 4–5 Termination board
locking set screw in the front end cap. Use a 1/16" hex wrench to perform
this task. When completed, unscrew the end cap.
away from the snap on standoffs.
LCD board to the G4 EX device.
Figure 4–6). Lift the board from the device.
J13 Jumper:
Jumper Pin1 to Pin 2 for DOUT
Jumper Pin 2 to Pin 3 for AI2
J5
J9 Terminates RS-485
+ DO -
J13
1 3
J19
COMM1
9
8
9
7
5
6
5
4
3
2
1
2
-
1
+
J16
PWR
Note:
Pinouts are shown to the outside for clarity,
but all of the Phoenix connectors are wired
and attached to the inside.
5 6 7 8 9
3
CTS/RBUS(-)
RXD/RBUS(+)
TXD/TBUS(-)
RTS/TBUS(+)
RRTS COMM2
OPERATE COMM2
COMM2 SW
GND
VBATT
COMM2
(RS-232/RS-485)
Jumpers for RS-485 Mode Only
If this is the last board on the bus, or if it is the
only board, jumper J9, Pin 1 to Pin 2.
There are a pair of jumper wires required for
RS-485 only: wire J19, Pin 9 to Pin 7 and
Wire Pin 8 to Pin 6 on the terminating board.
For all intermediate boards, Jumper J9, Pin 2
to Pin 3
on COMM1
COMM1
(RS-232/RS-485)
CTS/RBUS(-)
RXD/RBUS(+)
TXD/TBUS(-)
RTS/TBUS(+)
J9
RRTS COMM1
1
OPERATE COMM1
COMM2 SW
3
GND
S3
VBATT
RESET
(-)
(+)
Jumpers for RS-485 Mode Only
2104349 rev. AD