Setting Up The G4 Ex; Date/Time; Figure 3-13 System Setup - ABB XSeries G4 6200 User Manual

Figure 3–13 System setup
3.3

Setting up the G4 EX

Once the user has physically connected to the G4 EX, they must then instruct the
software of the programming device to connect to. At this time, the software will
actually read the device default values that are programmed at the factory. These
preset values are based on the type of product that the user has ordered and
programmed for the most widely used configuration.
Depending on the programming device that is being used, the following are
minimum required entries. Specific information required to complete each step is
discussed in the PCCU32 Help Files.

3.3.1 Date/time

The G4 EX date and time should be set before other tube parameters are entered.
This insures that events are properly dated and time tagged. Attention should be
given that the date and time are set correctly and should agree with the collection
equipment. PCCU32 or WinCCU can be used to update the date and time of the
device.
2104349 rev. AD Page 3–13