6.2.8 Internal PCCU connector reassembly (if previously installed)
1) Connect the cable from the PCCU assembly to the termination board.
2) Reinstall the four mounting standoffs. This will secure the termination board
6.2.9 Implementation
Page 28
1
AI1(+)
AI1(-)
AI2(+)
AI2(-)
AI3(+)
AI3(-)
AOut(+)
AOut(-)
J3
8
J1
Figure 6–4 I/O daughter card
to the device.
This drawing does not completely illustrate the installation
methods required for hazardous locations. Prior to any installation
in a Classified Hazardous Location, verify the installation methods
by the Control Drawing referenced on the product's name tag and
national and local codes.
DB-9 Connector to
Termination Board
(Mounted on back)
J2
DI1(+)
DI1(-)
DI2(+)
DI2(-)
DI3(+)
I/O Daughter Card
DI3(-)
DI4(+)
DI4(-)
1
8
1
8
2104349 rev. AD