Setup Of The G4 Ex For Ethernet Connectivity; Figure 3-7 System Setup Dialog Box - Bluetooth - ABB XSeries G4 6200 User Manual

9) It should be noted that if the Bluetooth adapter plugged into the computer is
10) Once the pair/connection has been made, the user will need to assign a
11) The user will then need to close the System Setup screen, and connect to

3.2.4 Setup of the G4 EX for Ethernet connectivity

To set up the G4 EX for an Ethernet connection, the user must first connect locally
using either the RS-232 or USB cable. Using the local connection allows the user
to setup the device for Ethernet connectivity.
Currently, there are a variety of methods for completing this task. The following
will cover two such methods.
3.2.4.1
1) Connect locally using either the RS-232 instructions or the USB instructions
2104349 rev. AD
one that is not supported, the user will receive a different screen in the
System Setup dialog box (see Figure 3–7). At this point, the user must use
their Windows software that came with the Bluetooth adapter, and set up a
pair/connection to the preferred Totalflow Bluetooth-enabled device.
Figure 3–7 System Setup dialog box - Bluetooth
communication port to it. After this is accomplished, the user can set the
com port in the drop-down list provided on the System Setup dialog box.
PCCU32 to communicate with the device.
Method one
covered in the previous section(s).
Page 3–7