ABB XSeries G4 6200 User Manual page 37

From the factory, the G4 EX has four general credits installed. Several system
configurations are possible with these four general credits:
-
-
-
Applications are divided into categories: standard, general, IEC and CO2. Other
application categories may be created in the future.
Standard applications typically support general applications as well as the basic
operation of the G4 EX unit. Standard applications do not require any credits to be
instantiated.
Standard applications include:
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
General applications typically provide some type of measurement, control, logging
and/or archival function. General applications include:
-
-
-
-
-
-
-
-
-
-
IEC applications are generally custom applications provided by Totalflow at the
customer's request. This might include special control and/or measurement
algorithms required by the customer. Multiple IEC applications can be instantiated
with a single IEC credit.
-
2104349 rev. AD
AGA-3 with Plunger Lift and Trending (uses 3 general credits)
Two AGA-3 (or AGA-7) tubes with Trending (uses 3 general credits)
AGA-3 with Pad Control and Plunger Lift (uses 3 general credits)
System Application
Communications
I/O Subsystem
Therms Master
Therms Slave
Analysis Trend System
LevelMaster
Pulse Accumulator
NGC Client
PID Controller
Operations
XMV Interface
Holding Registers
Units Conversion
Host Interface
Displays
AGA-3 Measurement
AGA-7 Measurement
V-Cone Measurement
Coriolis Gas
Alarm System
Shutdown
Plunger
PAD Controller
Pump Interface
Oil Custody Transfer Measurement
CO2 (NIST) applications each require a CO2 (NIST) credit.
Page 1–23