Figure 2-14 Solar Panel Installation - ABB XSeries G4 6200 User Manual

2.2.10.3
1) Attach the 2" pipe coupling to the top end of the 6270 OEU mounting pipe.
2) Install the 2" pipe extension into the coupling. Securely tighten.
3) Check the solar panel using the Digital Multi-meter to verify polarity and
4) Install the solar panel on the mounting bracket, if required, with the provided
5) Attach the solar panel mounting plate to the top end of the 2" extension pipe
6) For northern hemispheres, position the solar panel facing south; for
7) Do not connect the other end of the cable to the 6270 OEU until the main
8) Remove the hole plug from the OEU, and install the cord connector.
2104349 rev. AD
Figure 2–14 Solar panel installation
Step-by-step instructions
Securely tighten.
output voltage. Voltage varies depending on the amount of sun, angle to the
sun, etc.
hardware. Install the solar panel cable, if required.
with U-bolts and associated mounting hardware. Do not tighten the U-bolts
until the solar panel has been correctly oriented.
southern hemispheres, position the solar panel facing north. For optimum
charging, the solar panel should not be in shadows for any portion of the
day. The panel should be kept clean for maximum charging.
The sun's orientation in the sky varies from summer to
winter. Keep this in mind when installing the solar panel to
make sure there are no obstructions during the entire year.
battery pack has been connected and the user has been instructed to do so.
Page 2–15