ABB i-bus KNX Product Manual page 132
Vc/s 4.x.1 valve drive controller
Hide thumbs
Also See for i-bus KNX:
- Product manual (264 pages) ,
- Product manual (240 pages) ,
- Product manual (257 pages)
Table of Contents
Advertisement
®
ABB i-bus
KNX
Parameters
7.7.3.1
No
7.7.3.1.1
—
Dependent parameter
Comfort heating setpoint
This parameter is only visible if the Deactivated option has not been selected for the Basic-stage heating
parameter in the Application parameters parameter window, and the No option has been selected for the
Comfort heating setpoint = Comfort cooling setpoint parameter.
Options:
This value defines the setpoint for the heating comfort temperature. If the device is in the type of operation
heating and is changed to the Comfort operating mode, the device regulates to this temperature.
7.7.3.1.2
—
Dependent parameter
Comfort cooling setpoint
This parameter is only visible if the Deactivated option has not been selected for the Basic-stage heating
parameter in the Application parameters parameter window, and the No option has been selected for the
Comfort heating setpoint = Comfort cooling setpoint parameter.
Options:
This value defines the setpoint for the comfort cooling temperature. If the device is the type of operation
cooling and is changed to the Comfort operating mode, the device regulates to this temperature.
130 2CDC508220D0211 Rev. A | VC/S 4.x.1
10...21...40 °C
10...25...40 °C
Advertisement
Table of Contents
