Send Status Values - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Parameters
7.9.1.2.3 —
Dependent parameter
Valve drive opening/closing time
This parameter is visible if, in the Valve output parameter, the Thermoelectric (PWM) or Open/Close signal
option has been selected.
Options:
With this parameter, a time is set in seconds that the connected valve requires to move from position 0 %
(valve closed) to position 100 % (valve fully open), or the valve requires to move from 100 % to 0 %.
The time should be taken from the technical data of the valve, and it corresponds with the total runtime.
7.9.2

Send status values

Options:
This parameter defines when the valve output status values are to be sent. It affects the group objects
Status byte valve A, Fault: valve output A and Status Control value for the valve drive.
•
After a change: The values are sent after a change in the object values (e.g. change from 0 to 1).
With the Status Control value group object the values are only sent if the change in the control value is
at least 1 %.
•
Cyclically: If this option is selected, the status values are sent automatically after an adjustable time
has elapsed. Displays the dependent parameter All.
•
On request: The valve output status values are sent on the receipt of a command via the Request
status values group object.
•
After a change or request: The values are sent on request and on a change.
•
After a change or request and cyclically: The values are sent on request and on a change and
cyclically. Displays the dependent parameter All.
158 2CDC508220D0211 Rev. A | VC/S 4.x.1
10...60...900 s
Note
After a change
Cyclically
On request
After a change or on request
After a change or request and cyclically