Assignment Of The Physical Address - ABB i-bus KNX Product Manual
Vc/s 4.x.1 valve drive controller
Hide thumbs
Also See for i-bus KNX:
- Product manual (264 pages) ,
- Product manual (240 pages) ,
- Product manual (102 pages)
Table of Contents
Advertisement
®
ABB i-bus
KNX
Commissioning
6.3
Assignment of the physical address
The physical address, group address and parameters are assigned and programmed in ETS.
The device features a Programming button for physical address assignment. The red Programming LED
lights up after the button has been pressed. It goes off once ETS has assigned the physical address or the
Programming button is pressed again.
The device performs an ETS reset during physical address programming. This resets all states.
36 2CDC508220D0211 Rev. A | VC/S 4.x.1
Advertisement
Table of Contents
