Automatically Reset From Manual Operation To Knx Operation - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Parameters
7.3.2

Automatically reset from manual operation to KNX operation

Options:
This parameter is only visible if the Enabled option has been selected for the Manual operation parameter.
This parameter determines whether, after pressing the Manual operation button, the device will remain in
Manual operation or will be reset back to KNX operation.
•
yes: The device is reset to KNX operation depending on the parameterized time.
7.3.2.1 —
Dependent parameter
Time for automatic reset to KNX operation
Options:
This parameter determines how long, after pressing the Manual operation button, the device will remain in
Manual operation.
The device remains in Manual operation after the last button press until either the Manual operation button
is pressed again or the parameterized time has elapsed.
44 2CDC508220D0211 Rev. A | VC/S 4.x.1
No
Yes
00:00:30...00:05:00...18:12:15 hh:mm:ss