Selection Of Absolute - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Parameters
7.7.4.1

Selection of Absolute

7.7.4.1.1 —
Dependent parameter
Standby heating setpoint
This parameter is only visible if the device has been parameterized for heating and the Deactivated option
has not been selected for the Basic-stage heating parameter in the Application parameters parameter
window, and the Setpoint specification and adjustment parameter has been parameterized with the
Absolute option.
Options:
This parameter is used to set the temperature that is to apply in the Standby operating mode in the type of
operation heating.
The temperature stated here must be lower than the temperature selected in the Comfort heating
setpoint or Comfort heating and cooling setpoint parameter. A temperature that is at least 2 °C lower is
recommended.
The controller does not change the type of operation to reach this temperature, instead it ensures this
temperature is not dropped below on a reduction in the actual temperature.
7.7.4.1.2 —
Dependent parameter
Economy heating setpoint
This parameter is only visible if the device has been parameterized for heating and the Deactivated option
has not been selected for the Basic-stage heating parameter in the Application parameters parameter
window, and the Setpoint specification and adjustment parameter has been parameterized with the
Absolute option.
Options:
This parameter is used to set the temperature that is to apply in the Standby operating mode in the type of
operation heating.
The temperature stated here must be lower than the temperature selected in the Standby heating
setpoint parameter. A temperature that is at least 2 °C lower is recommended.
The controller does not change the type of operation to reach this temperature, instead it ensures this
temperature is not dropped below on a reduction in the actual temperature.
10...19...40 °C
Note
10...17...40 °C
Note
VC/S 4.x.1 | 2CDC508220D0211 Rev. A 133