Pg/Pc Interface Configuration - Siemens SINUMERIK 840D sl Commissioning Manual

13.4.2

PG/PC interface configuration

Introduction
Under NetPro, configure the interfaces required for commissioning at the PG/PC. These may
include the following interfaces:
● Ethernet for the communication for NCU socket X127
● PROFIBUS
Operator input sequence steps for configuring interfaces
1. Highlight the symbol "PG/PC" under NetPro.
2. Select "Object properties" <right mouse button >.
3. In the "Properties - PG/PC" dialog box displayed, select the "Interfaces" tab in the dialog
Figure 13-9
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
(see figure below).
Under this tab, define/configure all the required interfaces.
Properties - PG/PC
13.4 Integrating PG/PC into the network (NetPro)
Tips
225