Extending/Checking The Topology; Adding Components To The Topology - Siemens SINUMERIK 840D sl Commissioning Manual

Tips

13.7 Extending/checking the topology

13.7 Extending/checking the topology
13.7.1

Adding components to the topology

Introduction
If you connect a new encoder interface component (e.g. SMC20) via DRIVE-CLiQ to the
drive system, SINAMICS detects the change in the actual topology and sends the
actual/reference topology difference to the HMI.
The new component must be configured on the HMI and assigned to a drive object (Motor
Module) via the drive wizard.
Operating sequences
1. Select the menu "Drive system > Configuration".
Figure 13-20 Menu "Drive system > Configuration"
2. Press "Topology".
244
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive