Introduction To Commissioning Of Sinamics Drives - Siemens SINUMERIK 840D sl Commissioning Manual

Commissioning SINAMICS drives

8.1 Introduction to commissioning of SINAMICS drives

8.1 Introduction to commissioning of SINAMICS drives
Introduction
Commissioning of the SINAMICS drives is done in the operating area "Commissioning".
Introduction to commissioning of SINAMICS drives
1. After having completed commissioning of the PLC, you proceed from the following
operating interface.
Figure 8-1
2. Press the "Drive system" softkey.
Figure 8-2
62
"Commissioning" menu
There are two different ways to start in the "Commissioning" > "Drive system" menu:
– The drive system has not yet been commissioned (see following figure).
"Drive system" menu
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive