Software And Hardware Requirements - Siemens SINUMERIK 840D sl Commissioning Manual

Requirements for commissioning

3.2 Software and hardware requirements

Literature
● All information about the structure of SINAMICS S120 drive components are contained in:
● You can find all the instructions on how to connect the Ethernet interface here:
● To initialize an Ethernet, see also:
3.2 Software and hardware requirements
Requirements
For the commissioning of SINUMERIK 840D sl, the following points are required:
● Connection to NCU
● Software prerequisites
24
SINAMICS S120 Equipment Manual
Equipment Manual NCU
HMI commissioning; TCU commissioning
– Network switch or hub to socket X120
– Ethernet connection of PG/PC to socket X120 or socket X127 when commissioning
the HMI PLC external
– Ethernet machine control panel to socket X120
– Ethernet connection from TCU for internal HMI internal to Ethernet machine control
panel or
– Ethernet connection from PCU 50.3 for HMI external to Ethernet machine control
panel
– SIMATIC STEP 7 as of Version 5.3 Service Pack 3 on PC/PG (SIMATIC Manager)
– STEP7 package for NCU7x0 on PC/PG (Toolbox)
– GSD file (Toolbox)
– CompactFlash Card with software for internal HMI, NCK, PLC and drive
– External HMI on PCU 50.3 or IBN tool on PC/PG for the commissioning of internal
HMI
Note
The order numbers of the SINAMICS drives, motors and encoders should be at hand.
These are used for parameterization.
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive