22 Speed Feedback - ABB ACSM1 Firmware Manual

100
22

22 SPEED FEEDBACK

Firmware block:
SPEED FEEDBACK
(22)
Block outputs located in other
parameter groups
22.01 SPEED FB SEL
Selects the speed feedback value used in control.
(0) ESTIMATED
(1) ENC1 SPEED
(2) ENC2 SPEED
22.02 SPEED ACT FTIME
Defines the time constant of the actual speed filter, i.e. time within the actual speed has reached 63%
of the nominal speed (filtered speed =
If the used speed reference remains constant, the possible interferences in the speed measurement
can be filtered with the actual speed filter. Reducing the ripple with filter may cause speed controller
tuning problems. A long filter time constant and fast acceleration time contradict one another. A very
long filter time results in unstable control.
If there are substantial interferences in the speed measurement, the filter time constant should be
proportional to the total inertia of the load and motor, in this case 10...30% of the mechanical time
constant
t
mech
J = total inertia of the load and motor (the gear ratio between the load and motor must be taken into
tot
account)
n
nom
T
nom
See also parameter
0...10000 ms
Parameters and firmware blocks
= (n / T ) × J × 2π / 60, where
nom nom tot
= motor nominal speed
= motor nominal torque
26.06 SPD ERR
SPEED FEEDBACK
TLF8 250 μsec
[ Estimated ]
22.01 SPEED FB SEL
[ 3.000 ms ]
22.02 SPEED ACT FTIME
[ 1 ]
22.03 MOTOR GEAR MUL
[ 1 ]
22.04 MOTOR GEAR DIV
[ 30.00 rpm ]
22.05 ZERO SPEED LIMIT
[ 0 ms ]
22.06 ZERO SPEED DELAY
[ 0 rpm ]
22.07 ABOVE SPEED LIM
[ 500.0 rpm ]
22.08 SPEED TRIPMARGIN
[ Fault ]
22.09 SPEED FB FAULT
1.01 SPEED ACT (page 55)
FW block: SPEED FEEDBACK
Calculated speed estimate.
Actual speed measured with encoder 1. The encoder is selected by
parameter 90.01 ENCODER 1
Actual speed measured with encoder 2. The encoder is selected by
parameter 90.02 ENCODER 2
FW block: SPEED FEEDBACK
1.01 SPEED ACT).
FTIME.
Time constant for actual speed filter.
5
(2)
1.01 SPEED ACT
(see above)
SEL.
SEL.
(see above)