ABB ACSM1 Firmware Manual page 76

76
10.05 EXT2 START IN1
Selects the source 1 for the start and stop commands in external control location EXT2. See
parameter
Note: This parameter cannot be changed while the drive is running.
Bit pointer: Group, index and bit
10.06 EXT2 START IN2
Selects the source 2 for the start and stop commands in external control location EXT2. See
parameter
Note: This parameter cannot be changed while the drive is running.
Bit pointer: Group, index and bit
10.07 JOG1 START
If enabled by parameter
1. 1 = Active. (Jogging function 1 can also be activated through fieldbus regardless of parameter
10.15.)
See section
10.15 JOG
24.11 SPEED REF
SPEED
Note: This parameter cannot be changed while the drive is running.
Bit pointer: Group, index and bit
10.08 FAULT RESET SEL
Selects the source for the external fault reset signal. The signal resets the drive after a fault trip if the
cause of the fault no longer exists. 1 = Fault reset.
Bit pointer: Group, index and bit
10.09 RUN ENABLE
Selects the source for the run enable signal. If the run enable signal is switched off, the drive will not
start or stops if the drive is running. 1 = Run enable.
Note: This parameter cannot be changed while the drive is running.
Bit pointer: Group, index and bit
10.10 EM STOP OFF3
Selects the source for the emergency stop OFF3. 0 = OFF3 active: The drive is stopped along the
emergency stop ramp time,
Emergency stop can also be activated through fieldbus
See section
Note: This parameter cannot be changed while the drive is running.
Bit pointer: Group, index and bit
Parameters and firmware blocks
FW block:
10.04 EXT2 START FUNC
FW block:
10.04 EXT2 START FUNC
FW block:
10.15 JOG
Jogging on page 43. See also other jogging function parameters:
ENABLE, 24.03 SPEED REF1 IN
JOG2, 25.09 ACC TIME
DELAY.
FW block:
FW block:
FW block:
25.11 EM STOP
Emergency stop on page 50.
DRIVE LOGIC (see above)
selections (1) IN1 and (2)
DRIVE LOGIC (see above)
selection (2) 3-WIRE.
DRIVE LOGIC (see above)
ENABLE, selects the source for the activation of jogging function
/ 24.04 SPEED REF2
JOGGING, 25.10 DEC TIME JOGGING
DRIVE LOGIC (see above)
DRIVE LOGIC (see above)
DRIVE LOGIC (see above)
TIME.
(2.12 FBA MAIN
3-WIRE.
10.14 JOG2
IN, 24.10 SPEED REF
and 22.06 ZERO
CW).
START,
JOG1,