ABB ACSM1 Firmware Manual page 216

216
Code Fault
(fieldbus code)
0062 D2D SLOT COMM
(0x7584)
0201 T2 OVERLOAD
(0x0201)
0202 T3 OVERLOAD
(0x6100)
0203 T4 OVERLOAD
(0x6100)
0204 T5 OVERLOAD
(0x6100)
0205 A1 OVERLOAD
(0x6100)
0206 A2 OVERLOAD
(0x6100)
0207 A1 INIT FAULT
(0x6100)
0208 A2 INIT FAULT
(0x6100)
0209 STACK ERROR
(0x6100)
0210 FPGA ERROR
(0xFF61)
0301 UFF FILE READ
(0x6300)
Fault tracing
Cause
Drive-to-drive link is set to use
an FMBA module for
communication, but no module
is detected in specified slot.
Firmware time level 2 overload
Note: This fault cannot be
reset.
Firmware time level 3 overload
Note: This fault cannot be
reset.
Firmware time level 4 overload
Note: This fault cannot be
reset.
Firmware time level 5 overload
Note: This fault cannot be
reset.
Application time level 1 fault
Note: This fault cannot be
reset.
Application time level 2 fault
Note: This fault cannot be
reset.
Application task creation fault
Note: This fault cannot be
reset.
Application task creation fault
Note: This fault cannot be
reset.
Drive internal fault
Note: This fault cannot be
reset.
Drive internal fault
Note: This fault cannot be
reset.
File read error
Note: This fault cannot be
reset.
What to do
Check the settings of parameters
MODE and 57.15 D2D COMM
that the FMBA module has been detected by
checking parameters 9.20...9.22.
Check that the FMBA module is correctly
wired.
Try installing the FMBA module into another
slot. If the problem persists, contact your local
ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
57.01 LINK
PORT. Ensure