ABB ACSM1 Firmware Manual page 56

56
1.10 ENCODER 2 SPEED
Encoder 2 speed in rpm.
1.11 ENCODER 2 POS
Actual position of encoder 2 within one revolution.
1.14 SPEED ESTIMATED
Estimated motor speed in rpm.
1.15 TEMP INVERTER
Measured temperature of the heatsink in Celsius.
1.16 TEMP BC
Brake chopper IGBT temperature in Celsius.
1.17 MOTOR TEMP
Measured motor temperature in Celsius.
1.18 MOTOR TEMP EST
Estimated motor temperature in Celsius.
1.19 USED SUPPLY VOLT
Either the nominal supply voltage defined by parameter
automatically determined supply voltage if auto-identification is enabled by parameter
SUPPLVOLTAUTO-ID.
1.20 BRAKE RES LOAD
Estimated temperature of the braking resistor. The value is given in percent of the temperature the
resistor reaches when loaded with the power defined by parameter
1.21 CPU USAGE
Microprocessor load in percent.
1.22 INVERTER POWER
Drive output power in kilowatts.
1.26 ON TIME COUNTER
This counter runs when the drive is powered. The counter can be reset using the DriveStudio tool.
1.27 RUN TIME COUNTER
Motor run time counter. The counter run when the drive modulates. The counter can be reset using
the DriveStudio tool.
1.31 MECH TIME CONST
Calculated mechanical time constant of the system as identified by the speed control autotuning
routine.
Parameters and firmware blocks
FW block: ENCODER (page 161)
FW block: ENCODER (page 161)
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: MOT THERM PROT
FW block: MOT THERM PROT
FW block: VOLTAGE CTRL
47.04 SUPPLY
FW block: ACTUAL VALUES
FW block: None
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: None
(see above)
(see above)
(see above)
(page 138)
(page 138)
(page 145)
VOLTAGE, or the
(see above)
48.04 BR POWER MAX
(see above)
(see above)
(see above)
47.03
CNT.