Speed Ref Sel - ABB ACSM1 Firmware Manual

104
24.09 CONST SPEED ENA
24.08 CONST SPEED
3.01 SPEED REF1
3.02 SPEED REF2
24.05 SPEED REF 1/2 SEL
24.06 SPEED SHARE
1
-1
24.07 SPEEDREF NEG ENA
24.10 SPEED REF JOG1
24.11 SPEED REF JOG2
10.13 FB CW USED
bit 10 JOGGING
06.02 STATUS WORD 2
bit 5 JOGGING
24
24 SPEED REF MOD
Firmware block:

SPEED REF SEL

(23)
Selects the sources for two speed
references, REF1 or REF2, from a
selection list. Also shows the values
of both speed references.
The sources can alternatively be
selected with value pointer
parameters. See firmware block
SPEED REF MOD
Block outputs located in other
parameter groups
24.01 SPEED REF1 SEL
Selects the source for speed reference 1
Source for speed reference 1/2 can also be selected by value pointer parameter
IN /
(0) ZERO
(1) AI1
(2) AI2
(3) FBA REF1
(4) FBA REF2
Parameters and firmware blocks
x
x
on page 105.
24.04 SPEED REF2 IN.
20.03 POS SPEED ENA
20.01 MAXIMUM SPEED
06.01 STATUS WORD 1
bit 9 LOCAL FB
2.14 FBA MAIN REF1
Local speed reference
06.01 STATUS WORD 1 bit 11
LOCAL PANEL
46.02 SPEED REF SAFE
SAFE SPEED COMMAND
24.12 SPEED REF MIN ABS
20.02 MINIMUM SPEED
20.04 NEG SPEED ENA
06.02 STATUS WORD 2
bit 12 RAMP IN 0
TLF2 500 μsec
[ AI1 ]
24.01 SPEED REF1 SEL
[ ZERO ]
24.02 SPEED REF2 SEL
3.01 SPEED REF1 (page 63)
3.02 SPEED REF2 (page 63)
FW block: SPEED REF SEL
(3.01 SPEED
Zero reference.
Analogue input AI1.
Analogue input AI2.
Fieldbus reference 1.
Fieldbus reference 2.
0
0
0
SPEED REF SEL
3
(1)
3.01 SPEED REF1
3.02 SPEED REF2
(see above)
REF1).
03.03 SPEEDREF
RAMP IN
24.03 SPEED REF1