ABB ACSM1 Firmware Manual page 106

106
-8...8
24.07 SPEEDREF NEG ENA
Selects the source for the speed reference inversion. 1 = Sign of the speed reference is changed
(inversion active).
Bit pointer: Group, index and bit
24.08 CONST SPEED
Defines the constant speed.
-30000...30000 rpm
24.09 CONST SPEED ENA
Selects the source for enabling the use of the constant speed reference define by parameter
CONST
Bit pointer: Group, index and bit
24.10 SPEED REF JOG1
Defines the speed reference for jogging function 1. See section
-30000...30000 rpm
24.11 SPEED REF JOG2
Defines the speed reference for jogging function 2. See section
-30000...30000 rpm
24.12 SPEED REFMIN ABS
Defines the absolute minimum limit for the speed reference.
20.01 MAXIMUM SPEED
24.12 SPEED REFMIN ABS
–(24.12 SPEED REFMIN ABS
20.02 MINIMUM SPEED
0...30000 rpm
Parameters and firmware blocks
Scaling factor for speed reference 1/2.
FW block:
FW block:
Constant speed.
FW block:
SPEED. 1 = Enable.
FW block:
Speed reference for jogging 1.
FW block:
Speed reference for jogging 2.
FW block:
Absolute minimum limit for speed reference.
SPEED REF MOD (see above)
SPEED REF MOD (see above)
SPEED REF MOD (see above)
SPEED REF MOD (see above)
Jogging
SPEED REF MOD (see above)
Jogging
SPEED REF MOD (see above)
Limited speed reference
24.08
on page 43.
on page 43.
Speed reference