Siemens SIMATIC MV500 Operating Manual page 101

Menu command or
parameter
Cycle time
X position
Y position
Roll angle
Viewing angle (ID-
Genius decoder
for DMC only)
Smallest cell spac-
ing (ID-Genius
decoder for DMC
only)
Distance to border
(ID-Genius de-
coder for DMC
only)
SIMATIC MV500
Operating Manual, 05/2019, C79000-G8976-C495-02
Description
The processing time required for the code currently being read.
•
For the program currently being output:
the time from the internal trigger to the end of processing minus the time in
which the image is buffered.
If the size of the image buffer is > 1, images are buffered during scanning,
program sequence and individual trigger.
Min.: Minimum of the processing times of all the codes read since the last
•
startup
Max.: Maximum of the processing times of all the codes read since the last
•
startup
Average: Average of the processing times of all the codes read since the last
•
startup
Too short: Absolute and relative number of image processing procedures in
•
which the set high limit of the cycle time was exceeded.
X position of the center point of the first result relative to the center of the image.
Normalized to the full resolution for the current image.
Y position of the center point of the first result relative to the center of the image.
Normalized to the full resolution for the current image.
Roll angle of the center point of the first result for the current image corresponds
to a counterclockwise rotation.
Angle between the sensor axis and the surface of the code field for the current
image. Ideally, this angle is 90°.
Smallest cell spacing in pixels for the current image.
Smallest distance of a code boundary to the image border for the current image.
The value specified here is multiplied by the mean cell spacing.
Application
5.1 Program
101