Siemens SIMATIC MV500 Operating Manual page 92

Application
5.1 Program
Error code Message
(%c) (%s)
0001 No 1D/2D code found in step n
0002 Cycletime too short
0003 Trigger too fast
0004 Non ECC200 Code in step n
0005 Step n: Structured Append DMC not supported
0006 Step n: Reader Programming DMC not supported
0007 Step n: QR ECI encoding not supported
0008 Step n: QR Byte encoding not supported
0009 Step n: QR Kanji encoding not supported
0010 Step n: Structured Append QR code not support-
ed
0011 Step n: QR FNC1 encoding not supported
0012 Code quality is poor in step n
0013 Nothing found
0014 Found m instead of the expected number of
1D/2D codes in step n
0015 Maximum number of codes per image (m) was
exceeded in step n
0016 The maximum amount of data which can be de-
coded was exceeded in code m of step n
0017 Trigger during image acquisition
0018 Step timeout reached in step n
4700 Verification failed in step n
4701 Verification for code type found in step n not sup-
ported
92
Description
No code was found in step #n.
Processing was not completed within the cycle time
limit.
Processing was interrupted by a trigger signal.
A data matrix code was found in step #n that does not
correspond to ECC200.
Note
The check for ECC200 is performed only in adjust-
ment mode and during "Save program".
A "Structured Append" DMC type was found in step
#n. This DMC type is not supported.
A "Reader Programming Code" DMC type was found
in step #n. This DMC type is not supported.
A QR code with "ECI encoding" was found in step #n.
This QR type is not supported.
A QR code with "Byte encoding" was found in step #n.
This QR type is not supported.
A QR code with "Kanji encoding" was found in
step #n. This QR type is not supported.
A "Structured Append" QR type was found in step #n.
This QR type is not supported.
A QR code with "FNC1 encoding" was found in
step #n. This QR type is not supported.
A code with "poor" quality evaluation was read in
step #n during verification.
In "Scan" or "Auto-trigger" (edge-triggered) mode: All
image acquisitions were decoded without result.
Only "m" codes instead of the expected number of
codes were found in step # n during multicode decod-
ing.
More than the maximum number of codes per image
was found with multicode decoding (50, MV500 U/X:
150).
A maximum of 3001 bytes can be decoded per step.
This length was exceeded in step #n for code #m.
The trigger signal was applied during image acquisi-
tion. In this case, no (further) image acquisition is
started. Instead, image acquisition and processing are
being continued and an N_OK result is generated
immediately upon completion.
In step #n, the defined time limit was reached.
The read code could not be verified.
The selected verification method is not supported for
the code type found in step #n.
Operating Manual, 05/2019, C79000-G8976-C495-02
SIMATIC MV500