Siemens SINUMERIK 840D Operator's Manual page 149

4
03.04
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
· NC Stop status:
Only program lines that have not yet been executed can be edited.
· Reset status:
All program lines can be edited.
Note:
You cannot use the "Correct program" function if you are running a
program from the hard disk.
Other information
If the error cannot be corrected in the "Channel aborted" state, an
appropriate message is displayed when the "Correct block" softkey is
pressed.
In this case, program execution must be aborted with "NC Reset". The
part program can then be edited under Programming.
Machine Operating Area
4.6 Automatic mode
4
4-149