Siemens SINUMERIK 840D Operator's Manual page 396

7
"Services" Operating Area
7.6 Manage data
Manage
data
New
7-396
Activation
If a definition file is loaded, a prompt is displayed asking whether to
activate the file or retain the data. If you do not activate, the file is
not loaded.
If the cursor is positioned on a loaded definition file, the softkey
labeling changes from "Load" to "Activate" to activate the
definitions. If you select "Activate", another prompt is displayed
asking whether you want to retain the data.
Data is only saved for variable definition files, not for macros.
Other information
If there is insufficient memory space available to activate the
definition file, then the file must be unloaded. After the memory
size has been adjusted, the file must be loaded from the NC to the
HMI and back again to the NC. The files are then activated.
Creating a definition directory
The definition files available to the user
· SACCESS.DEF (_N_SACCESS_DEF)
·
MACCESS.DEF (_N_MACCESS_DEF)
·
UACCESS.DEF (_N_UACCESS_DEF)
are created and edited under the definition directory _N_DEF_DIR.
They do not need to be activated but are loaded to the passive file
system of the NCK as follows:
Select softkey "Manage data".
The horizontal and vertical softkey bars change.
Loading the definition directory in the HMI without modifying the
existing access authorization.
Changing write access
The following files which were installed during a series startup
·
SACCESS.DEF (_N_SACCESS_DEF)
· MACCESS.DEF (_N_MACCESS_DEF)
·
UACCESS.DEF (_N_UACCESS_DEF)
are created and edited under the definition directory _N_DEF_DIR.
They do not need to be activated but are loaded to the passive file
system of the NCK as follows:
Definition and creation of user data
See /PGA/, Programming Guide, Advanced.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
7
03.04
Ó Siemens AG, 2004. All rights reserved