Siemens SINUMERIK 840D Operator's Manual page 196

5
"Parameters" Operating Area
5.3 Tool management
Magazine
list
Tool
list
Load
Unload
Relocate
Working
offset list
Tool
catalog
Tool
cabinet
Trans-
formation
Special feature:
5-196
Horizontal softkeys
The first or most recently displayed magazine is shown in the
"Magazine list" together with all the tools which have been loaded.
You can access the next magazine by pressing the corresponding
vertical softkey.
All tools which are stored as a set of data on the NC are displayed
(irrespective of whether they have been assigned to a magazine
location).
A magazine location is assigned to the tool.
The tool is deleted from the current magazine location.
The tool is moved from the current magazine location to another
location.
The cutting edges of active replacement tools are displayed. They are
sorted in order of ascending D numbers.
Further softkeys are displayed when you press the "Etc." key:
You can create new tool master data ("ideal" tools) and modify the
existing data.
You can create new tool offset data and tool operating data ("real"
tools) and modify the existing data.
This softkey allows you to display the tool data as transformed data
(adapter data are calculated) or non-transformed data.
This conversion feature is only available in the magazine list display.
The data are always displayed as non-transformed data in the tool list
and as transformed data in the working offset list.
If you display transformed data and want to create a new tool in the
magazine list (loading mode), the transformed data display is
activated exclusively for input of this data block.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved