Siemens SINUMERIK 840D Operator's Manual page 320

6
"Program" Operating Area
6.9 Program simulation
Menu "Channel/spindle"
vertical
Channel/
spindle
Sequence
Program name
Start label
Stop label
Channel
Spindle
Skip
Milling
6-320
Can be accessed from RESET or STOP status only.
The screen shows the current execution list for the selected part
programs.
Simulation sequence of programs
List of programs
Path label from which a program is simulated. If this is not specified,
simulation takes place from program start.
Path label up to which a program is simulated. If this is not specified,
simulation takes place to program end.
(See also "Multi-channel, section by section program simulation".)
Processing channel in the SIMNCK interpreter
Turning: MS main spindle, CS counterspindle, var variable controlled
via NC vocabulary word.
(Milling: currently unused)
Skip. The designated section/program is not simulated in the current
session.
Leads to the manufacturer-specific channel settings (subject to correct
Channel
settings
password).
Constant machine arrangement
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
6
03.04
Ó Siemens AG, 2004. All rights reserved