Siemens SINUMERIK 840D Operator's Manual page 200

5
"Parameters" Operating Area
5.3 Tool management
(Names assigned by
user)
W. offset
list 1
W. offset
list 2
W. offset
list 3
Tool
data
Find
D number
Current
D number
5-200
Note
The data you enter are always updated immediately (without
prompting). You can change the properties of the new tool by
pressing the "Tool details" softkey.
It is not possible to modify the data directly in the table.
You can only change the name and type of a tool by selecting New-
Add, not via Tool details.
To change a name, you have to create a new tool and delete the old
one.
Vertical softkeys (working offset list)
Selection of a table structure configured by the user
(if configured), e.g.:
· General data
· Geometry tool data
· Wear data
You can display and edit the complete data of a tool (as in the
magazine list).
Find an entry with a specific D number/DL number.
· Enter the D number and DL number you want to find in the search
window.
· Confirm with "OK". If a matching entry is found, the cursor jumps to
the corresponding line. If you have not specified a DL number, the
cursor is positioned on the first line of the matching tool.
The D number of the current tool is determined and displayed.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved