Tool Offsets - Siemens SINUMERIK 840D Operator's Manual

5
"Parameters" Operating Area

5.2 Tool offsets

5.2 Tool offsets
5.2.1 Function and main screen for tool offsets
5-182
Offsets that are not required must be assigned the value 0 (= default
when the offset memory is set up).
The tool offsets can be entered not only via the operator panel front
but also via the data input interface.
For programming offset data see
/PG/, Programming Guide, Fundamentals
Tool offset data consist of data which describe the geometry, wear,
identification, tool type and the assignment to parameter numbers.
The unit used for the dimensions of the tool are displayed.
The input field is highlighted.
Parameter CHAN1
Channel active
Tool offset data
T number 1
Tool type 100
C. edge pos. 1
Geometry
Tool length comp.
Length 1 :
Length 2 :
Length 3 :
Radius comp.
Radius :
DP7.18.res
DPR.17.res
:
DP9.18.res
:
DP10,19.res
:
DP11,20.res :
:
Length compensation
Clear angle
DP25.res : :
Tool Setting
R
offset variables data
Every offset number contains up to 25 parameters depending on the
tool type.
The number of parameters shown in the window is that for the tool
type.
The maximum number of offset parameters (T and D numbers) can
be set by means of machine data.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
MPF.DIR
AUTO
TEST.MPF
Program running
D number 1 No. of c. edges
Wear Base
0.000 0.000
0.000 0.000 0.000
0.000 0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
Deg.
0.000
0.000
Zero User
data
offset
Ó Siemens AG, 2004. All rights reserved
5
03.04
T No.
+
T No.
-
1 D No.
+
D No.
-
mm
mm
mm Delete...
mm
Go to...
Overview...
New...
Determine
compens...