Enabling - Siemens SINUMERIK 840D Operator's Manual

6
03.04
6.10.11

Enabling

Change
enable
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Function
The program overview indicates whether a workpiece or part program
is enabled.
This means that it may be executed (e.g. because it has already been
tested) by the control after you select softkey "Program selection" and
the "NC Start" key.
If you set up a new program, it is automatically enabled.
Operating sequence
To set the enable for a program or abort it, position the cursor on the
desired workpiece or part program in the program overview.
Select softkey "Change enable".
A cross indicating "Enable issued" appears behind the workpiece or
part program.
(x)
Enable issued (program can be executed)
( )
No enable issued (program must not be executed)
Other information
· The system checks whether a program may be executed when the
program is called (after selection via operator input or from part
program). If an enable is required it must have been set previously.
(See also Chapter 6 "Changing properties of file/directory/archive")
"Program" Operating Area
6.10 Manage programs
6
6-355