Manage Programs; Overview - Siemens SINUMERIK 840D Operator's Manual

6
"Program" Operating Area

6.10 Manage programs

6.10 Manage programs

6.10.1 Overview

Program management
6-338
To allow you to handle data and programs flexibly, you can organize,
store and display them according to different criteria.
The memory is divided into:
·
NC memory (main memory and program memory) containing the
active system and user programs as well as all part programs for
immediate execution and
·
Hard disk drive
Programs can be exchanged with the program memory and hard disk.
Part programs may be stored either in the program memory of the NC
or on the hard disk, but they are always executed from the program
memory.
The "Load" and "Unload" functions are used to load or unload
programs to or from the program memory.
The programs and files are stored in different directories and can be
administered in the Program and Services operating areas.
The details are shown in the following overview:
Name of directories:
· Subroutines
·
Part programs
·
Workpieces
·
Definitions
·
Comments
·
Standard cycles
·
Manufacturer cycles
·
User cycles
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Operating area:
Programs and Services
Programs and Services
Programs and Services
Services
Services
Programs and Services
Programs and Services
Programs and Services
Ó Siemens AG, 2004. All rights reserved
6
03.04