Service Display; Service Overview (From Sw 6) - Siemens SINUMERIK 840D Operator's Manual

8
"Diagnosis" Operating Area

8.3 Service display

8.3 Service display

8.3.1 Service overview (from SW 6)

Service overview
Software version 6.3
and higher
In software version 6.3
and higher
In software version 6.3
and higher
8-408
Function
When commissioning digital drives and diagnosing faults, the various
operating states of individual machine axes can be visualized with a
type of traffic light indicator in the "Service overview" display, which
you can open from the "Service display" menu.
This overview shows specific enable signals and statuses for each of
the available axes 1 to 31. Up to 6 different states can occur on each
axis:
Columns for machine axes 1 to 31
Traffic light indicator states per axis
Green dot:
Amber dot:
Gray dot:
Red dot:
Dash:
Hash:
Rows with the drive diagnostic functions
Drive enable (terminal 64/63)
Pulse enable (terminal 64/48)
Pulse enable (term. 663 / SI: drive relay)
Setup mode (terminal 112)
PLC pulse enable
NC speed controller enable
DC link status
Enable pulses
Drive ready
Heatsink temperature warning
Power section in i2t limitation
Motor temperature warning
Measuring system 1 active
Measuring system 2 active
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
The axis is behaving normally
The axis is not ready
Does not concern this axis
An alarm is pending for this axis
No drive assigned to axis
Error reading the data
if e.g. data is missing
Ó Siemens AG, 2004. All rights reserved
8
03.04