Interface Parameters - Siemens SINUMERIK 840D Operator's Manual

7
03.04
Saving RS-232 interface
settings

7.4.1 Interface parameters

Parameters for archiving
with PG/PC
Interface:
Protocol:
Parity:
Stop bits:
Data bits:
Baud rate:
Archive format:
Parameters for DIN
programs
Interface:
Protocol:
Parity:
Stop bits:
Data bits:
Baud rate:
Archive format: Punched tape with ...
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
In HMI Advanced software version 6.2 or later, RS-232 interface
settings can be stored in specific files in the RS-232.DIR directory.
The parameters in a file can be assigned to one of the interfaces.
Additional functions are planned for managing/updating these files.
See Setting the RS-232 interface.
Default: RS-232-C PG/PC
This setting allows files in SINUMERIK 840D PC format to be
archived and imported.
"Stop with end of transmission character" must not be selected for
transmission of MSD and FDD files.
Other settings are possible with ASCII data. They must correspond to
those on the programmer. Cable 6FX 2002-1AA01- is used for this
purpose.
Default: RS-232-C user
COM1
RTS/CTS
None
¨
1
ý
8
9600
With this setting, programs conforming to DIN (beginning with %) are
read in or out.
7.4 RS-232 interface parameters
With leader and trailer
Stop with end of transmission character
Time monitoring (sec.):
"Services" Operating Area
RTS/CTS
>= 9600
Binary format (PC format)
04
7
COM2
1
8
7-375