Siemens SINUMERIK 840D Operator's Manual page 194

5
"Parameters" Operating Area
5.3 Tool management
Location (Pl)
Location state (P)
PTP
ToolID
Dupl
TNo
PTT
W (8x)
PV
5-194
Location number
Location state
(one column is provided for each state)
e.g.
F = Location enabled
G = Location disabled
Z = Reserved for tool in intermediate memory
B = Reserved for tool to be loaded
L = Left half location occupied
R = Right half location occupied
O = Upper half location occupied
U = Lower half location occupied
l = Left half location reserved (from SW 6.4)
r = Right half location reserved (from SW 6.4)
o = Upper half location reserved (from SW 6.4)
u = Lower half location reserved (from SW 6.4)
Type assigned to the location
Name of the tool
Number of replacement tool
Internal T numbers which may be needed for reloading tool data.
Type of location assigned to the tool
Tool status
(one column is provided for each status)
No display = Replacement tool
A = Active tool
F = Tool enabled
G = Tool disabled
M = Tool is measured
V = Prewarning limit is reached
W = Tool is being changed
P = Tool is fixed-location-coded
E = Tool has been used
R = Unloading marking ("radius")
B = Loading marking
S = Master tool
Wear group assigned to the tool.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved