Siemens SINUMERIK 840D Operator's Manual page 61

2
03.04
Find/
Go to...
Program
start
Program
end
Go to...
Find
OK
Abort
Find
next
or
Replace
or
Replace
all texts
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
2.6 General sequence of operation
Find/Go to...
The Find/Go to... dialog box opens.
You can select functions for positioning and searching via the vertical
softkeys:
The following search methods are available:
· to the beginning of the part program (cursor on the first character
in the program),
· the end of the part program (cursor on the last character in the
program) and
· to position on a particular NC block with "Go to.."
· or search for a particular character string with "Find".
"Go to...":...": Enter the required block number.
· If the line being searched for contains an "N" or ":", you are taken
to that line.
· A message is output if there is no block with the specified number.
Press softkey "OK" or the "Input" key to position the cursor on the
block number/line number of your choice.
The "Go to..." window is closed.
If you abort positioning, the process is stopped and the window
closed.
"Find":
Enter the character string you wish to find.
The string you enter is sought downwards from the current cursor
position, the find result appears as highlighted text.
You can start a new search by pressing softkey "Find next" or the
"Input" key.
Enter the new text with the "Replace" softkey.
The text found is replaced by the "replacement text". The new text is
replaced when you press "Input". Every time you press "Input", a new
find and replace process is started.
Enter the new text with the softkey "Replace all texts". The query asks
you "Do you really want to replace all non write protected strings: ...
globally with ... ?".
Note: This function can be interlocked with a password, see /IAM/ IM4
Installation and Start-up of HMI Advanced (PCU 50).
The function "Replace all texts" is only enabled for files located on the
hard drive (i.e. not in the NC memory).
Operator Components/Sequence of Operations
2
2-61