Siemens SINUMERIK 840D Operator's Manual page 229

5
03.04
Delete
Unload
Relocation
In the
cabinet
Update
filter
Recall "^"
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
"Unload"
"Delete" is initiated for the selected tools. Loaded tools are unloaded
prior to deletion. You are prompted to specify the unloading point in a
dialog box.
"Unload" is initiated for the selected tools. The tools are not deleted.
You are prompted to specify the unloading point in a dialog box.
"Relocation" is initiated for the selected tools. A dialog box prompts
you to enter the destination magazine where the tools are to be
relocated. This magazine is the destination for all tools in this batch
processing operation.
Job processing is initiated "In the cabinet" for the selected tools. This
function is similar to the "Delete" function; in addition, the tool data are
saved in the tool cabinet database. Loaded tools are unloaded before
being saved and deleted. In this case, the unloading point is queried
interactively.
The current filter and its magazine settings are used again and a new
hit list produced. The tool selection for job processing is canceled
completely.
The current number of hits is discarded and the 1st screen "Filter
selection" is displayed.
If batch processing has been started and the necessary entries have
been made, the display switches to the 3rd screen "Batch execution".
"Parameters" Operating Area
5.3 Tool management
5
5-229