Activate Tool Offset Immediately - Siemens SINUMERIK 840D Operator's Manual

5
"Parameters" Operating Area
5.2 Tool offsets

5.2.8 Activate tool offset immediately

5-190
Function
Machine data can be set to ensure that the active tool offset is
activated as soon as the part program is in the "Reset" or "Stop"
state.
Other information
If the function is used in the Reset state, machine data
$MC_RESET_MODE_MASK must be set such that the tool offset is
not reset on a Reset.
/FB/, Description of Functions, Fundamentals, K2 Axes, Coordinate
Systems...
Caution
The offset is applied after NC Start of the Reset in response to the
next programmed axis movement in the part program.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved