Siemens SINUMERIK 840D Operator's Manual page 226

5
"Parameters" Operating Area
5.3 Tool management
Precondition
I.
Select a filter
Filter 1-6
Magazine
selection
5-226
Operating sequence
Select the tool management
Softkey "Filter lists"
The screen provides up to 6 filters for selection by softkey depending
on the configuration in paramtm.ini.
Vertical softkeys
The softkey designation "Filter 1- 6" used by way of example provides
for labeling up to 6 filters. Pressing the softkey starts determining the
tools that match the criteria in the NC and jumps to a 2nd screen that
displays the hit list. The filter produces a snapshot of the data. This
data is not updated later.
You can use the filter definition to specify whether the filter always
applies to the whole TOA or is restricted only to single magazines.
You can use the "Magazine selection" softkey to select a particular
magazine or "All magazines" for a restrictable filter.
When you switch from a magazine list to the filter lists and no current
filter or job processing is active in the TOA (you access the first
screen "Filter selection"), the current magazine in the magazine list is
taken as the preset value for restrictable filters.
If the situation is the same when coming from the tool list, the preset
value is "All magazines".
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved