Setting Up Epson Rc; (Using The Cd-R/Rw Drive With Usb); Necessary Items; Starting Epson Rc+ Setup Program - Epson RC420 Manual

12.4 Setting Up EPSON RC+

This section describes the procedure for setting up EPSON RC+ with the CD-R/RW drive
that is connected to USB.
Prepare the following items for the EPSON RC+ installation.
EPSON RC+ Setup CD-ROM
USB connection CD-R/RW drive
(1) Connect the CD-R/RW drive to the USB connector on the RC420 Controller.
(2) Set the EPSON RC+ setup CD-ROM in the CD-R/RW drive.
(3) The [EPSON RC+ Setup] dialog is automatically opened. (If the dialog is not
Install EPSON RC+ following the procedure in the section 12.3.5 Installing EPSON
RC+.
Reserve address resources of the EPSON RC+ options following the procedure in the
section 12.3. 6 Reserving Address Resources of EPSON RC+ Options.
After setting up EPSON RC+, set up UPS and restore the back-up data. For details,
NOTE
refer to the Setup & Operation 10.6 Configuring Windows and Maintenance 2.5 Backup
of Data.
RC420 Rev.9

12.4.1 Necessary Items

Items

12.4.2 Starting EPSON RC+ Setup Program

automatically opened, select the [Start] - [Run] and enter the "d\epsonrc\setup.exe"
in the [Open] box, and then click the <OK> button.)

12.4.3 Installing EPSON RC+

12.4.4 Reserving Address Resources of EPSON RC+ Options

Maintenance 12. Recovering the HDD

(Using the CD-R/RW Drive with USB)

Attachment to RC420
Use the CD-R/RW drive that is run by the
standard driver in Windows 2000.
Note
159